|\===================================================================/| | \ SWAT MAGAZINE ISSUE TWENTY FIVE JANUARY 2000 / | | \_______________________________________________________________/ | | /===============================================================\ | | /================= Bug Device ===============\ | |/================== By _Smurf_ ================\| Introduction ============ It can successfully be used it for tapping fones, getting inside info, blackmail and other such things. The possibilities are endless. it is a very good bug that uses AM radio wave. Materials you will need ======================= (1) 9 volt battery with battery clip (1) 25-mfd, 15 volt electrolytic capacitor (2) .0047 mfd capacitors (1) .022 mfd capacitor (1) 51 pf capacitor (1) 365 pf variable capacitor (1) Transistor antenna coil (1) 2N366 transistor (1) 2N464 transistor (1) 100k resistor (1) 5.6k resistor (1) 10k resistor (1) 2meg potentiometer with SPST switch wire, solder, soldering iron, PCB board [!] ! 51 pf ! ---+---- ------------base collector ! )( 2N366 +----+------/\/\/----GND 365 pf () emitter ! ! )( ! ! +-------- ---+---- ! ! ! ! ! ! ! GND / .022mfd ! ! 10k\ ! ! ! / GND +------------------------emitter ! ! ! 2N464 / .0047 ! base collector 2meg \----+ ! ! +--------+ ! / ! GND ! ! ! GND ! ! ! +-------------+.0047+--------------------+ ! ! ! +--25mfd-----+ -----------------------------------------+ ! ! microphone +--/\/\/-----+ ---------------------------------------------+ 100k ! ! GND---->/<---------------------!+!+!+---------------+ switch Battery from 2meg pot. Notes about the plans ====================== 1. GND means ground 2. The GND near the switch and the GND by the 2meg potentiometer should be connected. 3. Where you see: )( () )( it is the transistor antenna coil with 15 turns of regular hook-up wire around it. 4. The middle of the loop on the left side (the left of "()") you should run a wire down to the "+" which has nothing attached to it. There is a .0047 capacitor on the correct piece of wire. 5. For the microphone use a magnetic earphone (1k to 2k). 6. Where you see "[!]" is the antenna. Use about 8 feet of wire to broadcast approx 300ft. Part 15 of the FCC rules and regulation says you can't broadcast over 300 feet without a license. (Hahaha). Use more wire for an antenna for longer distances. (Attach it to the black wire on the fone line for about a 250 foot antenna!) Operation ========== This transmitter will send the signals over the AM radio band. You use the variable capacitor to adjust what freq. you want to use. Find a good unused frequency down at the lower end of the scale and you're set. Use the 2 meg pot. to adjust gain. The switch on the 2meg is for turning the bug on and off. When everything is adjusted, turn on an AM radio adjust it to where you think the signal is. Say some shit thru the mic and tune in to it.