Path: cdrom.com!barrnet.net!decwrl!hookup!europa.eng.gtefsd.com!howland.reston.ans.net!EU.net!sunic!news.funet.fi!ngw!news.funet.fi!not-for-mail
From: "." <AMIR77@taunivm.tau.ac.il>
Newsgroups: alt.cd-rom
Subject: HELP! Mitsumi FX001D installation! Please help me!!!!!! ASAP!
Date: 25 May 1994 22:27:38 +0300
Organization: FUNET-NGW
Lines: 21
Sender: daemon@news.funet.fi
Distribution: alt
Message-ID: <CDROM-L%94052511551473@UCCVMA.UCOP.EDU>
Reply-To: "." <AMIR77@taunivm.tau.ac.il>
NNTP-Posting-Host: news.funet.fi
Comments: To: OS/2 list <OS2-L@NIC.SURFNET.NL>,
          "OS2 (users) list" <os2users@vm1.mcgill.ca>,
          PCBUILD List <PCBUILD@TSCVM.BITNET>, CDROM-L <cdrom-l@uccvma.ucop.edu>
To: CDROM-L Redistribution <lst-alt-cd-rom@news.funet.fi>

Hi All,

I just installed my Mitsumi FX001D drive. The power was ok,
and the CD door goes in and out.
I understand that this drive can be connected to a Sound Blaster Pro
card, and so I did. I tried to install its DOS drivers,
and it asked me for its IRQ, DMA, ADDR. What should I answer?
I could even install the OS/2 mitsumi drivers. I "selective" installed
installed the drivers, but even after I rebooted there was nothing new.

(I also have a I/F card that came with it. I'd really like to connect
it to the SB, but if this isn't possible, I can install the I/F card.
What IRQ, Addr, DMA should I choose? (irq 10 is used by the Adaptec
1542CF SCSI controller, I think. the SB is 220, and IRQ 5)


Any help would be appriciated... :(

Thanks,
     Rann Glaser
     amir77@taunivm.tau.ac.il